Honda Fit: Automatic / General information
- A/T Differential Backlash Inspection (A/T)
- A/T Differential Carrier Bearing Preload Inspection (A/T)
- A/T Differential Carrier and Final Driven Gear Replacement (A/T)
- A/T Housing Idler Gear Shaft Removal and Installation (A/T)
- A/T Housing Reverse Idler Gear Installation (A/T)
- A/T System Description - Hydraulic Controls (A/T)
- A/T System Description - Lock-Up System (A/T)
- ATF Replacement (A/T)
- Automatic Transmission Removal (A/T)
- Clutch Clearance Inspection (A/T)
- Clutch Disassembly (A/T)
- Intermediate Shaft Reassembly (A/T)
- Intermediate Shaft Removal (A/T)
- Mainshaft Disassembly, Inspection, and Reassembly (A/T)
- Output Shaft (Countershaft) Speed Sensor Replacement (A/T)
- Secondary Shaft 2nd Gear Axial Clearance Inspection (A/T)
- Secondary Shaft Disassembly, Inspection, and Reassembly (A/T)
- Shaft Assembly and Housing Installation (A/T)
- Shift Cable Adjustment (A/T)
- Transmission End Cover Park Lever Stop Inspection and Adjustment (A/T)
- Transmission End Cover Removal (A/T)
- Special Tools Required
- Transmission End Cover Transmission Fluid Pressure Switch Replacement (A/T)
See also:
Torque Converter Housing Lubrication Check Valve Replacement (A/T)
Remove the sealing bolt (A) and the sealing washer (B).
Remove the lubrication check valve (C) from the torque converter housing
(D).
Install the lubrication check val ...
Brake Light, Taillight, Back-Up Light and Rear Turn
Signal Light Bulbs
When replacing, use the following bulbs.
Brake/Taillight: 21/5 W
Back-Up Light: 16 W
Rear Turn Signal Light: 21 W (Amber)
1. Pry on the edge of the cover using a flat-tip
screwdriver to remove ...
Transmission End Cover Removal (A/T)
Special Tools Required
Mainshaft Holder 07GAB-PF50101
Remove the bolts securing the ATF inlet line (D) and ATF filter holder
(E), the line bolt and sealing washers, and remove the ATF in ...
Categories
