Honda Fit: Output Shaft (Countershaft) Speed Sensor Replacement (A/T)
-
Remove the air cleaner assembly.
-
Disconnect the output shaft (countershaft) speed sensor connector, and remove the output shaft (countershaft) speed sensor (A).
-
Install a new O-ring (B) on the new output shaft (countershaft) speed sensor, then install the output shaft (countershaft) speed sensor.
-
Check the connector for rust, dirt, or oil, then connect the connector securely.
-
Install the air cleaner assembly.
See also:
Brake Light, Taillight, Back-Up Light and Rear Turn
Signal Light Bulbs
When replacing, use the following bulbs.
Brake/Taillight: 21/5 W
Back-Up Light: 16 W
Rear Turn Signal Light: 21 W (Amber)
1. Pry on the edge of the cover using a flat-tip
screwdriver to remove ...
How to Refuel
1. Stop your vehicle with the service station
pump on the left side of the vehicle in the
rear.
2. Turn off the engine.
3. Press the area indicated by the arrow to
release the fuel fill door. Y ...
Installation (Part -2)
Set the front subframe (A) with the steering gearbox on the transmission jack and support it.
@font-face{font-family:
"Honda_SymbolMarkeng";src:url( ...
Categories
