Honda Fit manuals

Honda Fit: Honda Fit 2007-2024 Navigation Online Reference Manual

Second generation (2007-2024) / Honda Fit 2007-2024 Navigation Online Reference Manual

The information and specifications included in this publication were in effect at the time of approval for printing. Honda Motor Co., Ltd., reserves the right, however, to discontinue or change specifications or design at any time without notice and without incurring any obligation.

Accessories Precautions The GPS antenna is located in the dashboard. Metallic front or side window tinting can seriously degrade or obstruct GPS reception.

Signal noise from devices such as radar detectors, vehicle tracking devices, remote starters, and additional amplifiers can disrupt the navigation system. If you install any such item, install it away from the navigation display and antenna.

Important Safety Information

WARNING

Using the navigation system while driving can take your attention away from the road, causing a crash in which you could be seriously injured or killed.

Only operate system controls when the conditions permit you to safely do so.

Avoid focusing on the screen or manually operating the system controls while driving.

Certain on-screen controls are disabled when driving, but most of the audible instructions and voice commands continue to function. Pull to the side of the road if you need to devote more attention and time to look at the screen or access additional menus.

Route guidance may conflict with street closures, road construction, detours, and out-of-date map data.

The system itself

NOTICE

This vehicle’s navigation display, if so equipped, includes mercury-containing components. Upon removal, please reuse, recycle, or dispose of as hazardous waste.

Clean the screen with a soft, damp cloth. You may use a mild cleaner intended for use on navigation screens.

See also:

Fuel and Emissions System Description - Catalytic Converter System
Catalytic Converter   System Warm Up Three Way Catalytic Converter   (WU-TWC) and Under-floor Three Way Catalytic Converter (Under-floor TWC) The WU-TWC and the under-flo ...

Rectifier Test
Check for continuity in each direction, between the B terminal and P terminals, and between the E terminal and P terminals of each diode pair. All diodes should have continuity in only one ...

Rotor Slip Ring Test
Measure the resistance between the slip rings (A): If the resistance is within the standard, go to step 22. If the resistance is not within the standard, replace the roto ...

© 2024 Copyright www.hfitinfo.com