This section describes the useful functions incorporated into the navigation system.
Piston Installation
If the Crankshaft is Already Installed
Set the crankshaft to bottom dead center (BDC) for each cylinder as its
piston is installed.
Remove the connecting rod caps, and check that ...
Radiator Replacement
Raise the vehicle on the lift.
Drain the engine coolant.
Disconnect the ECT sensor 2 connector (A), then remove the harness clamp
(B).
With A/C: Re ...
Heating and Cooling
Using Vents, Heating and A/C
■Heating
The heater uses heat from the engine coolant
to warm the air.
1. Adjust the fan speed using the fan control
dial.
2. Select and
.
3. Adjust t ...