Honda Fit manuals

Honda Fit: Splash Shield Replacement

NOTE:

  1. Remove the splash shield (A).

    1. From the wheel arch on both sides, remove the clips (B) securing the front splash shield and the front inner fender (C) to the body, and remove the clips (D) securing the front splash shield to the body.

    1. From under the front bumper (E), remove the clips (F) and the screws (G).

    1. From under the body, remove the screws (H) securing the front splash shield to the front inner fender, and the clips (I) securing the front splash shield to the front suspension subframe.

    1. Release the hooks (J) of the front splash shield from the front inner fender, then pull the splash shield out.

      NOTE: To release the clips, pry up on the center pin at the notch (K).

  2. Fastener Locations: Clip, 8B, D, F, I: Screw, 4G, HKKCECJAJGFFGDBDBIIHH
  3. Install the splash shield in the reverse order of removal, and note these items:

    • If the clips are damaged or stress-whitened, replace them with new ones.

    • Push the clips and the hooks into place securely.

See also:

Voice Help
This navigation system comes with voice help information, which tells you how to use the voice command functions. Go to Voice Info for tips when using the voice command functions. ...

Roof Molding Replacement
Special Tools Required KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: Take care not to scratch the body. Take ...

Front Passenger's Airbag Replacement (Removal)
NOTE: If replacing the front passenger's airbag after deployment, refer to Component Replacement/Inspection After Deployment   for a complete list of other parts that must also be r ...

© 2026 Copyright www.hfitinfo.com