Block and Piston Inspection
Remove the crankshaft and the pistons.
Check the piston for distortion or cracks.
Measure the piston skirt diameter (A) at a point 16 mm (0.63 in)
from ...
Inspection
Install the nut on the damper shaft end, and set the socket wrench and
T-handle on the nut.
Compress the damper assembly by hand, and check for smooth operation
through a full ...
Transmission Side - Release Bearing Inspection
Check the play of the release bearing by spinning it by hand. If there is
excessive play or noise, replace the release bearing.
NOTE: The release bearing is packed with grease. Do not ...