Inspection
Install the flange nut on the damper shaft end, and set the socket wrench
and T-handle on the nut.
Compress the damper assembly by hand, and check for smooth operation
through ...
HFL Switch Replacement
SRS components are located in this area.
Review the SRS component location, and the
precautions and procedures in the SRS section before
doing repairs or service.
Remove the ...
M/T Differential Thrust Clearance Adjustment (M/T)
Special Tools Required
Driver Handle, 40 mm I.D. 07746-0030100
Remove the left driveshaft side oil seal from the transmission housing.
If you remove the 80 mm shim (A) fro ...