Honda Fit: Torque Converter Housing Mainshaft Bearing and Oil Seal Replacement (A/T)
Special Tools Required
- Adjustable Bearing Puller, 25пјЌ40 mm 07736-A01000B
- Driver Handle, 15 x 135L 07749-0010000
- Bearing Driver Attachment, 62 x 68 mm 07746-0010500
- Bearing Driver Attachment, 72 x 75 mm 07746-0010600
-
Remove the mainshaft bearing and oil seal using the adjustable bearing puller (20пјЌ40 mm) and a commercially available 3/8 ''-16 slide hammer (A).
-
Install the new mainshaft bearing until it bottoms in the torque converter housing using the driver handle and the bearing driver attachment (62 x 68 mm).
-
Install the new oil seal flush with the housing using the driver handle and the bearing driver attachment (72 x 75 mm).
See also:
Emergency Towing
If your vehicle needs to be towed, call a professional towing service or organization.
Never tow your vehicle with just a rope or chain. It is very dangerous.
There are two ways to tow your vehicle ...
Wheel Speed Sensor Replacement
Front
Turn the ignition switch to LOCK (0).
Remove the grommet (A), then disconnect the wheel speed sensor connector
(B).
@font-face{font-famil ...
Adjusting the Sound
Press the (sound) button, and
rotate
to adjust the setting.
Each time you press the button, a
sound
mode switches as follows.
When the adjustment level reaches the center, you
will ...
Categories
