Remove the steering column covers.
Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B).
Turn the steering wheel to access the wiper/washer switch screws (C).
Remove the two screws, then slide out the wiper/washer switch.
Inspect the connector terminals to be sure they are all making good contact.
If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
If the terminals look OK, go to step 6.
Check for continuity between the terminals in each switch position according to the table.
Wiper
Rear window wiper
If the continuity is not as specified, replace the switch.
Install the switch in the reverse order of removal.
Cellular Phone Commands
The system accepts these commands only
on the PHONE screen.
Redial
Call History
Phonebook
Dial
Phone Setup
Phone Menu
Speed Dial 1
Speed Dial 2
More Speed Dial Lists
These commands can be m ...
Adjusting the Seats
WARNING
Sitting too close to a front airbag can result
in serious injury or death if the front
airbags inflate.
Always sit as far back from the front
airbags as possible while maintaining
cont ...
Driver's Seat Position Sensor Operation Check
Check the driver's seat position sensor after the driver's seat position
sensor replacement.
Make sure the driver's seat is all the way forward position.
Make sure the ...