Honda Fit: Transmission End Cover Transmission Fluid Pressure Switch Replacement (A/T)
-
Remove the transmission fluid pressure switch A (2nd clutch) (A).
-
Make sure there is no water, oil, dust, or foreign particles inside the connector.
-
Install the new transmission fluid pressure switch A (2nd clutch) and a new sealing washer (B), and tighten the metal part of the switch.
-
Remove the transmission fluid pressure switch B (3rd clutch) (C).
-
Make sure there is no water, oil, dust, or foreign particles inside the connector.
-
Install the new transmission fluid pressure switch B (3rd clutch) and a new sealing washer (D), and tighten the metal part of the switch.
See also:
Output Shaft (Countershaft) Speed Sensor Replacement (M/T)
M/T
Raise the vehicle on a lift.
Disconnect the output shaft (countershaft) speed sensor connector (A).
Remove the output shaft (countershaft) speed sensor (B).
...
Drive Belt Inspection
Inspect the belt for cracks or damage. If the belt is cracked or damaged,
replace it.
Check that the position of the auto-tensioner indicator (A) is within the
standard range ( ...
Front Lower Arm Removal/Installation
Special Tools Required
Ball Joint Thread Protector, 14 mm 071AF-S3VA000
Ball Joint Remover, 28 mm 07MAC-SL0A202
notice
Do not remove the lower arm from both sides a ...
Categories
