Honda Fit: Transmission End Covers

See also:

M/T Differential Thrust Clearance Adjustment (M/T)
Special Tools Required Driver Handle, 40 mm I.D. 07746-0030100 Remove the left driveshaft side oil seal from the transmission housing. If you remove the 80 mm shim (A) fro ...

Engine Block Drain Bolt/Sealing Bolt Installation
NOTE: When installing the drain bolt (A), always use a new washer. When installing the sealing bolt(s) (B), always use a new bolt(s) and washer(s) (C). ...

Engine Oil Filter Feed Pipe Replacement
Remove the filter. Remove the oil filter feed pipe. Install two 20 x 1.5 mm nuts (A) onto the new oil filter feed pipe, and hold one nut with a wrench, then ti ...