Honda Fit: Transmission End Cover Park Lever Stop Inspection and Adjustment (A/T)
-
Set the park lever in the P position.
-
Measure the center-to-center distance (A) between the park pawl shaft (B) and the park lever roller pin (C).
Standard:
37.8пјЌ38.8 mm (1.49пјЌ1.53 in)
-
If the measurement is out of standard, select and install the appropriate park lever stop (A) from the table.
-
After replacing the park lever stop, make sure the distance is within tolerance.
PARK LEVER STOP
|
Mark |
B |
C |
|
1 |
11.00 mm |
11.00 mm |
|
2 |
10.80 mm |
10.65 mm |
|
3 |
10.60 mm |
10.30 mm |
See also:
Daytime Running Lights
The high beam headlights come on slightly dimmer than normal when the
following
conditions have been met:
• The ignition switch is in ON .
• The headlight switch is off, or in .
• The park ...
Selecting a Destination on the Map
Select a new destination when en route by selecting a location on the map.
1. Scroll the map to position the
cursor over your desired
destination, adjusting the map
scale as necessary. Press the ...
Front Passenger's Weight Sensor Output Check After a Vehicle Collision
NOTE: Check the front passenger's weight sensor output after this action:
After a vehicle collision
Pre-Operation Check Set-up
Make sure all the components of the front passeng ...
Categories
