Honda Fit: Frame and Structure

See also:

Driver's Seat Position Sensor Replacement
Removal NOTE: Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor. Do the battery terminal disconnection ...

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

SRS Component Replacement/Inspection After Deployment
NOTE: Before doing any SRS repairs, check for DTCs, for the less obvious deployed components (seat belt tensioners, front impact sensors, side impact sensors, etc). If there is ...