Middle Front Floor Crossmember Torque
NOTE: Take care not to scratch the body.
Clutch Disc Inspection and Removal
Remove the clutch disc (A), the remover handle (B), and the clutch
alignment shaft (C).
Inspect the lining of the clutch disc for signs of slipping or oil. If
the clutch di ...
Transmission Side - Release Bearing Inspection
Check the play of the release bearing by spinning it by hand. If there is
excessive play or noise, replace the release bearing.
NOTE: The release bearing is packed with grease. Do not ...
Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque
its locknut to 110 N·m (11.2 kgf·m, 81 lbf·ft).
Remove any grease or any oil from the ...