Honda Fit manuals

Honda Fit: Front Individual Map Light Test/Replacement (With Navigation)

Second generation (2007-2026) / Honda Fit 2007-2026 Repair Manual / Accessories / Navigation and Telematics / Front Individual Map Light Test/Replacement (With Navigation)

With navigation

  1. Turn the individual map light switch OFF.

  1. Carefully pry the lens (A) off with a small screwdriver.

    Individual Map Light:

    8 W x 2

  2. BCA
  3. Remove the two screws, then remove the individual map light (B).

  4. Disconnect the connectors (C) from the individual map light.

  5. Check for continuity between the terminals.

    • There should be continuity between terminal No. 1   and the ground terminal with the switch in the ON position.

    • There should be no continuity between terminal No. 1 and the ground terminal with the switch in the OFF position.

  6. If the continuity is not as specified, check the bulb. If the bulb is OK, replace the individual map light.

  7. Install the light in the reverse order of removal.

See also:

EPS Control Unit Removal/Installation
Do the battery terminal disconnection procedure. Remove the under-dash fuse/relay box. Disconnect EPS control unit connector A (11P) and connector B (16P) by pus ...

Preparing to Drive
You should do the following checks and adjustments before you drive your vehicle. 1. Make sure all windows, mirrors, and outside lights are clean and unobstructed. Remove frost, snow, or ice. 2. C ...

List of Categories
* Stored in “Fav. Subcategory” by factory default. ...

© 2026 Copyright www.hfitinfo.com