Honda Fit: Navigation and Telematics

See also:

Piston Installation
If the Crankshaft is Already Installed Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. Remove the connecting rod caps, and check that ...

Removal
Raise and support the vehicle. Remove the rear wheel. Remove the wire guide grommet (A) from both sides of the axle beam. @font-face ...

Park Pin Switch Replacement (A/T)
NOTE: The park pin switch is installed in the shift lever bracket base, and not available separately from the shift lever bracket base; replace the park pin switch and the shift lever bracket base ...