Piston Installation
If the Crankshaft is Already Installed
Set the crankshaft to bottom dead center (BDC) for each cylinder as its
piston is installed.
Remove the connecting rod caps, and check that ...
Ignition Switch
The ignition switch has four positions: LOCK (0), ACCESSORY (I), ON (II), and
START (III).
LOCK (0) - You can insert or remove the key only in this position.
To turn the key, push it in slightly ...
Ball Joint Removal
Special Tools Required
Ball Joint Thread Protector, 10 mm 07AAF-SECA120
Ball Joint Thread Protector, 14 mm 071AF-S3VA000
Ball Joint Remover, 28 mm 07MAC-SL0A202
notice
...