Honda Fit: A/T Differential Backlash Inspection (A/T)
-
Install the driveshaft and intermediate shaft into the differential assembly, and place the axles on V-blocks (A).
-
Measure the backlash of the pinion gears (B) with a dial indicator (C).
Standard:
0.05пјЌ0.15 mm (0.002пјЌ0.006 in)
-
If the backlash is out of standard, replace the differential carrier.
See also:
Seat Belt Inspection
Out of Vehicle
For front seat belt retractors with seat belt tensioners,
review the SRS component locations and
the precautions and procedures before doing
repairs or serv ...
Entering a Destination
DEST button
This section describes how to enter a destination for route guidance.
Select an item.
Select DEST Menu 2 to display
additional menu entries.
The following items are avail ...
Adjusting the Sound
Press the (sound) button, and
rotate
to adjust the setting.
Each time you press the button, a
sound
mode switches as follows.
When the adjustment level reaches the center, you
will ...
Categories
