Honda Fit: Transmission End Cover Transmission Fluid Pressure Switch Replacement (A/T)
-
Remove the transmission fluid pressure switch A (2nd clutch) (A).
-
Make sure there is no water, oil, dust, or foreign particles inside the connector.
-
Install the new transmission fluid pressure switch A (2nd clutch) and a new sealing washer (B), and tighten the metal part of the switch.
-
Remove the transmission fluid pressure switch B (3rd clutch) (C).
-
Make sure there is no water, oil, dust, or foreign particles inside the connector.
-
Install the new transmission fluid pressure switch B (3rd clutch) and a new sealing washer (D), and tighten the metal part of the switch.
See also:
On-Screen Commands
The system accepts these commands on
any screen. There are over 100 on-screen
commands. Say what is written on the
screen to activate that selection. For lists,
you can say the list item number to ...
Steering Wheel Installation
SRS components are located in this area.
Review the SRS component locations, and the
precautions and procedures before doing
repairs or service.
Before installing the steering ...
Camshaft Inspection
Remove the camshaft sprocket.
Remove the rocker arm assembly, then disassemble the rocker arm.
Put the rocker shaft holder bridge on the cylinder head, then tight ...
Categories
