Honda Fit manuals

Honda Fit: Disassembly

  1. Compress the damper spring, then remove the nut (A) while holding the damper shaft with a hex wrench (B). Do not compress the damper spring more than necessary to remove the nut.

  2. A12 x 1.25 mmB
  3. Release the pressure from the strut spring compressor, then disassemble the damper as shown in the Exploded View.


See also:

Fuse Locations
If any electrical devices are not working, turn the ignition switch to LOCK (0 and check to see if any applicable fuse is blown. Fuse locations are shown on the fuse box cover. Locate the fuse i ...

Calculating the Route on the Destination Map
Calculate the route from the map of the destination address. Select Calculate the Route. ► The system calculates and displays the route line on the map screen. ‚ÄúDisplay Destination Map‚ ...

Transmission End Cover ATF Feed Pipe Replacement (A/T)
Remove the snap ring (A), the 3rd clutch feed pipe (B), and the feed pipe flange (C) from the end cover (D). Install a new O-ring (E) over the 3rd clutch feed pipe. In ...

© 2024 Copyright www.hfitinfo.com