This section gives information about the controls and displays that contribute to the daily operation of your vehicle. All the essential controls are within easy reach.
Alternator Brush Inspection
Measure the length of both brushes (A) with a vernier caliper:
If either brush is shorter than the service limit, replace the brushes,
go to step
20.
If brush length ...
Countershaft Inspection (M/T)
Inspect the gear and bearing contact areas for wear and damage, then
measure the countershaft at points A, B, and C. If any part of the
countershaft is less than the service limit, replace ...
Automatic Transmission
■Creeping
The engine may run at a higher idle speed and creeping increases:
• Immediately after the engine starts.
• When the heating and cooling system is in use.
Keep the brake pedal f ...