Honda Fit: Clutch Replacement (M/T)
Second generation (2007-2026) / Honda Fit 2007-2026 Repair Manual / Powertrain / Transmission/Transaxle / Manual / Clutch Replacement (M/T)
Special Tools Required
- Clutch Alignment Disc 07JAF-PM7011A
- Clutch Alignment Shaft 07JAF-PM7012A
- Clutch Alignment Shaft 07ZAF-PR8A100
- Ring Gear Holder 07LAB-PV00100
- Weight, Remover 07741-0010201
- Driver Handle, 15 x 135L 07749-0010000
- Remover Handle 07936-3710100
- Bearing Remover Shaft Set, 15 mm 07936-KC10500
- Bearing Driver Attachment, 28 x 30 mm 07946-1870100
Engine Side
- Pressure Plate Inspection and Removal
- Clutch Disc Inspection and Removal
- Flywheel Inspection
- Flywheel Replacement
- Pilot Bearing Inspection
- Pilot Bearing Replacement
- Clutch Disc and Pressure Plate Installation
- Transmission Side - Release Bearing Removal
- Transmission Side - Release Bearing Inspection
- Transmission Side - Release Bearing Installation
See also:
Automatic Transmission
■Creeping
The engine may run at a higher idle speed and creeping increases:
• Immediately after the engine starts.
• When the heating and cooling system is in use.
Keep the brake pedal f ...
Output Shaft (Countershaft) Speed Sensor Replacement (M/T)
M/T
Raise the vehicle on a lift.
Disconnect the output shaft (countershaft) speed sensor connector (A).
Remove the output shaft (countershaft) speed sensor (B).
...
Customer Service Information
Honda dealership personnel are trained professionals. They should be able to
answer all your questions.
If you encounter a problem that your dealership does not solve to your satisfaction,
please ...
Categories
© 2026 Copyright www.hfitinfo.com