Honda Fit: Valvetrain

See also:

Alternator Brush Inspection
Measure the length of both brushes (A) with a vernier caliper: If either brush is shorter than the service limit, replace the brushes, go to step 20. If brush length ...

Mainshaft Reassembly (M/T)
Exploded View Special Tools Required Driver Handle, 40 mm I.D. 07746-0030100 Bearing Driver Attachment, 30 mm I.D. 07746-0030300 NOTE: Refer to the Exploded Viewas neededduring this proc ...

Automatic Transmission
■Creeping The engine may run at a higher idle speed and creeping increases: • Immediately after the engine starts. • When the heating and cooling system is in use. Keep the brake pedal f ...