Honda Fit: Valve Inspection
-
Remove the valves.
-
Measure the valve in these areas.
Intake Valve Dimensions
A Standard (New):
27.85пјЌ28.15 mm (1.0965пјЌ1.1083 in)
B Standard (New):
118.55пјЌ119.15 mm (4.6673пјЌ4.6909 in)
C Standard (New):
5.48пјЌ5.49 mm (0.2157пјЌ0.2161 in)
C Service Limit:
5.45 mm (0.2146 in)
Exhaust Valve Dimensions
A Standard (New):
22.85пјЌ23.15 mm (0.8996пјЌ0.9114 in)
B Standard (New):
117.25пјЌ117.85 mm (4.6161пјЌ4.6398 in)
C Standard (New):
5.45пјЌ5.46 mm (0.2146пјЌ0.2150 in)
C Service Limit:
5.42 mm (0.2134 in)
See also:
Turn Signals
The turn signals can be used when the ignition
switch is in ON .
...
Controls
Turn Signals
Turn Signal Control Lever
Lights
Light Control Switches
Wipers and Washers
Wiper/Washer Control Lever
MIST
OFF
INT: Low speed with intermittent
LO: Low speed wipe
HI: High ...
Ball Joint Boot Inspection/Replacement
Special Tools Required
Bearing Driver Attachment, 40 mm 07GAF-SE00200
Check the ball joint boot for weakness, damage, cracks, and grease leaks.
NOTE:
If the ball joint boot is ...
Categories
