Honda Fit: Cylinder Block
- Block and Piston Inspection
- Connecting Rod and Crankshaft End Play Inspection
- Intermediate Shaft Reassembly (A/T)
- Intermediate Shaft Removal (A/T)
- Crankshaft Main Bearing Replacement
- Connecting Rod and Crankshaft End Play Inspection
- Connecting rod Specification(s)
- Piston, Pin, and Connecting Rod Replacement
- Connecting Rod Bolt Inspection
- Piston Installation
See also:
Tire Pressure Monitoring System (TPMS) - Required Federal Explanation
U.S. models
Each tire, including the spare (if provided), should be checked monthly when
cold and inflated to the inflation pressure recommended by the vehicle
manufacturer on the vehicle placard o ...
Rear Seat-Back Cover/Pad Replacement
Special Tools Required
KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call
888-424-6857
NOTE:
Use the appropriate tool from the KTC trim to ...
Output Shaft (Countershaft) Speed Sensor Replacement (A/T)
Remove the air cleaner assembly.
Disconnect the output shaft (countershaft) speed sensor connector, and
remove the output shaft (countershaft) speed sensor (A).
...
Categories
