Honda Fit: Dashboard Vent Removal/Installation
Side Vent
Click here for an interactive version of this procedure (driver's, passenger's).
NOTE: Take care not to scratch the dashboard or its related parts.
-
Pull the upper portion (A) of the side vent (B) toward you to release the hooks (C), then remove the side vent.
-
Install the side vent in the reverse order of removal, and push the hooks into place securely.
Driver's side
Passenger's side
Center Vent
NOTE: Take care not to scratch the dashboard or its related parts.
-
Remove these items:
-
Audio unit, without navigation system ('9-11 models)
-
Audio unit, without navigation system ('12-13 model)
-
Audio-navigation unit, with navigation system ('9-11 models)
-
Audio-navigation unit, with navigation system ('12-13 model)
-
-
Remove the screws, then remove the center vent panel (A) from the center panel (B).
-
Release the hooks (C), then remove the center vent (D) from the center vent panel.
-
Install the center vent in the reverse order of removal, and push the hooks into place securely.
See also:
Alternator Brush Inspection
Measure the length of both brushes (A) with a vernier caliper:
If either brush is shorter than the service limit, replace the brushes,
go to step
20.
If brush length ...
Wheel Runout Inspection
Raise and support the vehicle.
Check for a bent or deformed wheel.
Set up the dial gauge as shown, and measure the axial runout by turning
the wheel.
...
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK
. Turn
headlights and all accessories off.
2. Check the fuses in the engine
compartment.
► If the fuse is blown, have it replaced by a
dealer.
3. I ...
Categories
