Honda Fit manuals

Honda Fit: Connecting Rod and Crankshaft End Play Inspection

  1. Remove the oil pump.

  1. Measure the connecting rod end play with a feeler gauge (A) between the connecting rod (B) and the crankshaft (C).

    Connecting Rod End Play

    Standard (New):

    0.15пјЌ0.35 mm (0.006пјЌ0.013 in)

    Service Limit:

    0.40 mm (0.015 in)

  1. If the connecting rod end play is beyond the service limit, install a new connecting rod, and recheck. If it is still beyond the service limit, replace the crankshaft.

  1. To check crankshaft end play, push the crankshaft firmly away from the dial indicator by prying, and zero the dial against the end of the crankshaft. Then pull the crankshaft firmly back toward the indicator by prying; the dial reading should not exceed the service limit.

    Crankshaft End Play

    Standard (New):

    0.10пјЌ0.35 mm (0.0039пјЌ0.0138 in)

    Service Limit:

    0.45 mm (0.0177 in)

  1. If the end play is beyond the service limit, replace the thrust washers, and recheck. If it is still beyond the service limit, replace the crankshaft.

See also:

Transmission End Cover ATF Feed Pipe Replacement (A/T)
Remove the snap ring (A), the 3rd clutch feed pipe (B), and the feed pipe flange (C) from the end cover (D). Install a new O-ring (E) over the 3rd clutch feed pipe. In ...

Front Lower Arm Removal/Installation
Special Tools Required Ball Joint Thread Protector, 14 mm 071AF-S3VA000 Ball Joint Remover, 28 mm 07MAC-SL0A202 notice Do not remove the lower arm from both sides a ...

Warranty Coverages
U.S. Owners Your new vehicle is covered by these warranties: New Vehicle Limited -covers your new vehicle, except for the battery, emissions control systems, and accessories against defects in mat ...

© 2026 Copyright www.hfitinfo.com