Honda Fit: Connecting rod Specification(s)
Connecting rod
|
Item |
Measurement |
Qualification |
Standard or New |
Service Limit |
|
Connecting rod |
Pin-to-rod interference |
0.019пјЌ0.036 mm (0.00075пјЌ0.00142 in) |
пјЌ |
|
|
Small end bore diameter |
17.964пјЌ17.977 mm (0.70724пјЌ0.70775 in) |
пјЌ |
||
|
Big end bore diameter |
Nominal |
43.0 mm (1.693 in) |
пјЌ |
|
|
End play |
0.15пјЌ0.35 mm (0.0059пјЌ0.0138 in) |
0.40 mm (0.0157 in) |
See also:
Accessory Power Socket Test/Replacement
NOTE: If the accessory power socket does not work, check the No. 13 (20 A) fuse
in the under-dash fuse/relay box and ground (G502) first.
Remove the dashboard center lower trim.
...
Rear Door Rear Sash Trim Replacement
NOTE: Take care not to scratch the door or related parts.
Remove the door quarter inner trim.
Remove the screw securing the trim to the door quarter.
...
Radiator Connecting Pipe Replacement
Drain the engine coolant.
Remove the thermostat housing.
Remove the connecting pipe (A).
Install the connecting pipe with a new O-ring (B).
...
Categories
