Honda Fit: Torque Converter Housing Lubrication Check Valve Replacement (A/T)
-
Remove the sealing bolt (A) and the sealing washer (B).
-
Remove the lubrication check valve (C) from the torque converter housing (D).
-
Install the lubrication check valve, a new sealing washer, and the sealing bolt.
See also:
M/T Differential Thrust Clearance Adjustment (M/T)
Special Tools Required
Driver Handle, 40 mm I.D. 07746-0030100
Remove the left driveshaft side oil seal from the transmission housing.
If you remove the 80 mm shim (A) from ...
Fuel Recommendation
Your vehicle is designed to operate on unleaded gasoline with a pump octane number
of 87 or higher. Use of a lower octane gasoline can cause a persistent, heavy metallic
rapping noise that can lea ...
MAP Sensor Replacement
Disconnect the MAP sensor connector (A).
Remove the MAP sensor (B).
Install the parts in the reverse order of removal with a new O-ring (C).
...
Categories
