Alternator Brush Inspection
Measure the length of both brushes (A) with a vernier caliper:
If either brush is shorter than the service limit, replace the brushes,
go to step
20.
If brush length ...
Disassembly
Compress the damper spring, then remove the nut (A) while holding the
damper shaft with a hex wrench (B). Do not compress the damper spring more
than necessary to remove the nut.
...
Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque
its locknut to 110 N·m (11.2 kgf·m, 81 lbf·ft).
Remove any grease or any oil from the ...