Honda Fit: Stator Test
-
Check that there is continuity between each lead (A):
-
If there is continuity, go to step 24.
-
If there is no continuity, replace the stator.
-
-
Check for continuity between each lead and the coil core (B):
-
If there is no continuity, go to step 25.
-
If there is continuity, replace the stator.
-
See also:
A/T Differential Carrier Bearing Preload Inspection (A/T)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 72 x 75 mm 07746-0010600
Preload Inspection Tool 07HAJ-PK40201
NOTE: If the transmission housing, torq ...
ODS Unit Replacement
Removal
Do the battery terminal disconnection procedure,
then wait at least 3 minutes before starting work.
Disconnect the passenger's side airbag harness 2P connector. ...
Output Shaft (Countershaft) Speed Sensor Replacement (M/T)
M/T
Raise the vehicle on a lift.
Disconnect the output shaft (countershaft) speed sensor connector (A).
Remove the output shaft (countershaft) speed sensor (B).
...
Categories
