Honda Fit: Side Vent
Click here for an interactive version of this procedure (driver's, passenger's).
NOTE: Take care not to scratch the dashboard or its related parts.
-
Pull the upper portion (A) of the side vent (B) toward you to release the hooks (C), then remove the side vent.
-
Install the side vent in the reverse order of removal, and push the hooks into place securely.
Driver's side
Passenger's side
See also:
MAF Sensor/IAT Sensor Replacement
Disconnect the MAF sensor/IAT sensor connector (A).
Remove the screws (B).
Remove the MAF sensor/IAT sensor (C).
Install the parts in the reverse order of removal ...
Engine Compression Inspection
NOTE: After the inspection, you must reset the ECM/PCM. Otherwise, the
ECM/PCM will continue to stop the injectors from operating.
Allow the engine to reach operating temperature (fan comes o ...
Mainshaft Assembly Clearance Inspection (M/T)
NOTE: If replacement is required, always replace the synchro sleeve and the
synchro hub as a set.
Support the bearing inner race with an appropriate size socket (A), and
push down on the m ...
Categories
