Special Tools Required
*Available through the Honda Tool and Equipment Program; call 888-424-6857
With Front Fog Lights
NOTE:
Take care not to scratch the front bumper.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Remove the front bumper.
Remove the clips, and release the hooks (A), then remove the lower front bumper grille (B) from the front bumper (C).
NOTE: To release the clips, pry up on the center pin at the notch (D).
Install the bumper grille in the reverse order of removal, and note these items:
If the clips are damaged or stress-whitened, replace them with new ones.
Push the clips and the hooks into place securely.
Models with 7 positions AT Shifting
Change the shift position in accordance with your driving needs.
■ Shift lever positions
You cannot turn the ignition switch to LOCK
and
remove the key unless the shift lever is in
.
...
A/F Sensor Replacement
Special Tools Required
O2 Sensor Wrench Snap-on S6176 or equivalent, commercially available
Remove the cowl cover and the under-cowl panel.
Disconnect the A/F se ...
A/T Differential Carrier Bearing Preload Inspection (A/T)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 72 x 75 mm 07746-0010600
Preload Inspection Tool 07HAJ-PK40201
NOTE: If the transmission housing, torq ...