Honda Fit: Transmission Unit
Second generation (2007-2026) / Honda Fit 2007-2026 Repair Manual / Powertrain / Transmission/Transaxle / Automatic / Transmission Unit
- A/T Countershaft Reverse Selector Hub Installation (A/T)
- A/T Secondary Shaft Sealing Ring Replacement (A/T)
- Transmission Housing Bearing Installation (A/T)
- Transmission Housing and Shaft Assembly Removal (A/T)
- VIN, Engine, (Motor), Transmission Numbers, and Paint Codes
- A/T System Description - Clutches and Gears (A/T)
- Clutch Wave-Plate Phase Difference Inspection (A/T)
- Transmission End Cover Selector Control Shaft Oil Seal Replacement (A/T)
- A/T Clutch Pressure Control Solenoid Valve B and C Replacement (A/T)
- Paddle Shifter (Downshift Switch) Replacement (A/T)
- Shift Solenoid Valve Removal and Installation (A/T)
- Servo Body Disassembly, Inspection, and Reassembly (A/T)
- Transmission End Cover Air Check Valve Inspection and Replacement (A/T)
- Main Valve Body Disassembly, Inspection, and Reassembly (A/T)
- Regulator Valve Body Disassembly, Inspection, and Reassembly (A/T)
- Valve Body and ATF Strainer Removal (A/T)
See also:
MAP Sensor Replacement
Disconnect the MAP sensor connector (A).
Remove the MAP sensor (B).
Install the parts in the reverse order of removal with a new O-ring (C).
...
Ball Joint Boot Inspection/Replacement
Special Tools Required
Bearing Driver Attachment, 40 mm 07GAF-SE00200
Check the ball joint boot for weakness, damage, cracks, and grease leaks.
NOTE:
If the ball joint boot is ...
If the Engine Overheats
The high temperature indicator should be off under most conditions.
If the engine coolant temperature gets higher than normal, the indicator will
blink. If it stays on, you should determine the rea ...
Categories
© 2026 Copyright www.hfitinfo.com