Honda Fit: Paddle Shifter (Downshift Switch) Replacement (A/T)
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
-
Remove the steering wheel.
-
Remove the four screws (A) securing the steering wheel rear cover (B), then remove the steering wheel rear cover.
-
Remove the paddle shifter пјЌ (downshift switch) connector (A) from its holder, and disconnect the connector.
-
Remove the screws (B) securing the paddle shifter пјЌ (C), and remove the paddle shifter пјЌ.
-
Install a new paddle shifter пјЌ on the steering wheel, and secure it with the screws.
-
Connect the paddle shifter пјЌ connector securely, and install the connector in the connector holder.
-
Install the steering wheel rear cover.
-
Install the steering wheel.
See also:
Clutch Disc Inspection and Removal
Remove the clutch disc (A), the remover handle (B), and the clutch
alignment shaft (C).
Inspect the lining of the clutch disc for signs of slipping or oil. If
the clutch di ...
Handles and Remote Openers
Rear Door Outer Handle Replacement
Special Tools Required
KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
Put on glove ...
Valve Inspection
Remove the valves.
Measure the valve in these areas.
Intake Valve Dimensions
A Standard (New):
27.85пјЌ28.15 mm (1.0965пјЌ1.108 ...
Categories
