Honda Fit: A/T Clutch Pressure Control Solenoid Valve B and C Replacement (A/T)
-
Remove the air cleaner assembly.
-
Remove the breather hose (A) from its clamp (B), and remove the breather hose clamp bracket (C).
-
Disconnect the connectors (A) from A/T clutch pressure control solenoid valve B and C.
-
Remove A/T clutch pressure control solenoid valve B and C.
-
Remove the ATF pipe (D), the ATF joint pipes (E), the O-rings (F), and the gasket (G).
-
Clean the mounting surface and fluid passages of the transmission housing.
-
Install a new gasket with blue side down; white side up on the transmission housing.
-
Install the ATF pipe and the ATF joint pipes, and install new O-rings over the ATF joint pipes.
-
Install A/T clutch pressure control solenoid valve B and C.
-
Check the connectors for rust, dirt, or oil, clean or repair if necessary, then connect the connectors securely.
-
Install the breather hose clamp bracket, and install the breather hose on its clamp at the dot.
-
Install the air cleaner assembly.
See also:
Braking System
Your vehicle is equipped with front disc brakes. The brakes on the rear wheels
are drum. A power assist helps reduce the effort needed on the brake pedal. The
anti-lock brake system (ABS) helps yo ...
HandsFreeLink System Description
HandsFreeLink Control Unit Connector for Inputs and Outputs
...
Glove Box Striker Replacement
SRS components are located in this area.
Review the SRS component locations and
the precautions and procedures before doing
repairs or service.
NOTE: Take care not to scra ...
Categories
