Honda Fit: Glove Box Striker Replacement
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE: Take care not to scratch the dashboard or its related parts.
-
While holding the glove box (A), release the glove box stops (B) on each side from the dashboard by pushing them inward, then lower the glove box.
-
Remove the screws, then remove the glove box striker (A).
-
Install the glove box striker in the reverse order of removal.
See also:
Protecting Infants and Small Children
Protecting Infants
Child Seat Type
An infant must be properly restrained in a rear-facing, reclining child seat
until the child reaches the seat maker’s weight or height limit for the seat, an ...
MAF Sensor/IAT Sensor Replacement
Disconnect the MAF sensor/IAT sensor connector (A).
Remove the screws (B).
Remove the MAF sensor/IAT sensor (C).
Install the parts in the reverse order of removal ...
Emissions Testing
Testing of Readiness Codes
If you take your vehicle for an emissions test shortly after the battery has
been disconnected or gone dead, it may not pass the test.
This is because of certain ‘‘r ...
Categories
