Special Tools Required
Remove the oil seal from the end cover.

Install the new oil seal flush with the end cover using the driver handle and the bearing driver attachment (22 x 24 mm).

Opening the Hood
1. Park the vehicle on a level surface, and set
the parking brake.
2. Pull the hood release handle under the
lower left corner of the dashboard.
► The hood will pop up slightly.
3. Push ...
Disassembly
Raise and support the vehicle.
Remove the rear wheels.
Release the parking brake, and
remove the brake drum.
Remove the tension pins (A) by pushing respe ...
Mainshaft Disassembly, Inspection, and Reassembly (A/T)
Inspect the thrust needle bearings and the needle bearings for galling
and rough movement.
Inspect the splines for excessive wear and damage.
Check the shaft bearing s ...