Honda Fit: Intake and Forced Induction

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Transmission Range Switch Replacement (A/T)
Raise the vehicle on a lift, or apply the parking brake, block the rear wheels, and raise the front of the vehicle. Make sure it is securely supported. Shift to N. ...

Throttle Body Removal/Installation
caution Do not insert your fingers into the installed throttle body when you turn the ignition switch to ON (II) or while the ignition switch is in ON (II). If you d ...