Honda Fit: Driveline

See also:

M/T Differential Thrust Clearance Adjustment (M/T)
Special Tools Required Driver Handle, 40 mm I.D. 07746-0030100 Remove the left driveshaft side oil seal from the transmission housing. If you remove the 80 mm shim (A) from ...

Secondary Shaft 2nd Gear Axial Clearance Inspection (A/T)
Install the thrust needle bearing (A), the needle bearing (B), 2nd gear (C), the thrust needle bearing (D), the 43 x 54.5 mm thrust washer (E), the 39 mm cotters (F), and the cotter retain ...

Clutch Wave-Plate Phase Difference Inspection (A/T)
Place the clutch wave-plate (A) on a surface plate, and set a dial indicator (B) on the wave-plate. Find the bottom (C) of a phase difference of the wave-plate, zero the di ...