With navigation
Turn the individual map light switch OFF.
Carefully pry the lens (A) off with a small screwdriver.
|
Individual Map Light: |
8 W x 2 |
Remove the two screws, then remove the individual map light (B).
Disconnect the connectors (C) from the individual map light.
Check for continuity between the terminals.
There should be continuity between terminal No. 1 and the ground terminal with the switch in the ON position.
There should be no continuity between terminal No. 1 and the ground terminal with the switch in the OFF position.
If the continuity is not as specified, check the bulb. If the bulb is OK, replace the individual map light.
Install the light in the reverse order of removal.
Seat Belt Inspection
Out of Vehicle
For front seat belt retractors with seat belt tensioners,
review the SRS component locations and
the precautions and procedures before doing
repairs or serv ...
Maintenance Safety
All service items not detailed in this section should be performed by a certified
technician or other qualified mechanic.
Important Safety Precautions
To eliminate potential hazards, read the inst ...
Playing Bluetooth® Audio
Your audio system allows you to listen to music tracks stored on your
Bluetoothcompatible
phone.
This function is available when the phone is linked to the vehicle’s Bluetooth®
HandsFreeLink ...