Honda Fit: Torque Converter Housing Countershaft Bearing Replacement (A/T)
Special Tools Required
- Adjustable Bearing Puller, 25пјЌ40 mm 07736-A01000B
- Driver Handle, 15 x 135L 07749-0010000
- Oil Seal Driver Attachment, 58 mm 07JAD-PH80101
-
Remove the countershaft bearing using the adjustable bearing puller (20пјЌ40 mm) and a commercially available 3/8 ''-16 slide hammer (A).
-
Install the ATF guide plate (A).
-
Install the new countershaft bearing (B) in the housing using the driver handle and the oil seal driver attachment (58 mm); install the bearing outer race surface in height (C) of 0.03 mm (0.001 in) above the housing surface (D). Do not install the bearing exceeding 0.03 mm (0.001 in) high from housing surface.
See also:
Showing Icons on the Map
MAP MENU (on map)
►Show icon on Map
The icon bar along the bottom of the screen allows you to select the icons
that are
displayed on the map.
Select an icon in the icon bar.
► Se ...
Intersection
DEST button
►DEST Menu 2►Intersection
Select the intersection of two streets as the destination. The state or
province for
your current location is displayed at the top of the screen ...
Windshield Washers
Check the fluid level in the windshield washer reservoir at least monthly during
normal use.
Check the fluid level by removing the cap and looking at the level gauge
On Canadian models: The low ...
Categories
