Honda Fit: Transmission Range Switch

See also:

Driveshaft Installatio
NOTE: Before starting installation, make sure the mating surfaces of the joint and the splined section are clean. Apply about 5 g (0.18 oz) moly 60 paste (P/N 08734-0001) to the contact ar ...

Countershaft Inspection (M/T)
Inspect the gear and bearing contact areas for wear and damage, then measure the countershaft at points A, B, and C. If any part of the countershaft is less than the service limit, replace ...

HFL Menus
Use HFL when the vehicle’s ignition is in the ACCESSORY (I) or ON (II) position. You can operate HFL by voice when on the PHONE screen. Below is the flow chart showing available voice commands ...