Honda Fit: M/T Differential Backlash Inspection (M/T)
-
Place the differential assembly on V-blocks (A), and install the right driveshaft (B) and the left driveshaft (C).
-
Measure the backlash of both pinion gears (D) with a dial indicator (E). If the backlash is not within the standard, replace the differential carrier.
Standard (New):
0.05-0.15 mm (0.0020-0.0059 in)
See also:
Map Scale Commands
Display north up
Display heading up
Display zoom in
Display zoom out
Display (specify scale):
1/20 mile (80 m) scale
1/8 mile (200 m) scale
1/4 mile (400 m) scale
1/2 mile (800 m) scale
1 mil ...
Malfunction Indicator Lamp
If this indicator comes on while driving, it means one of the engine’s emissions
control systems may have a problem. Even though you may feel no difference in your
vehicle’s performance, it ...
Audio Antenna
Your vehicle is equipped with an antenna at the rear of the roof . Bef ore
using a ‘‘drive-through’’ car wash, remove the antenna by unscrewing it by hand.
This prevents the antenna f ...
Categories
