Honda Fit: Restraints Control

See also:

Subframe Replacement
Front Subframe Torque NOTE: After loosening the subframe mounting bolts, be sure to replace them with new ones. Loosely install new front subframe mounting bolts, then tighten the b ...

Piston Installation
If the Crankshaft is Already Installed Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. Remove the connecting rod caps, and check that ...

Transmission Side - Release Bearing Installation
Apply high temp urea grease (P/N 08798-9002) to the release fork (A), the release fork bolt (B), the release bearing (C), and the release bearing guide (D) in the shaded areas, then set th ...