Honda Fit manuals

Honda Fit: Rear Door Rear Sash Trim Replacement

NOTE: Take care not to scratch the door or related parts.

  1. Remove the door quarter inner trim.

  1. Remove the screw securing the trim to the door quarter.

  2. Fastener Location: Screw, 1BCA??B
  3. Pull up the door rear sash trim (A) to release the hooks (B, C), then remove it from the door.

  4. Install the trim in the reverse order of removal.

See also:

Output Shaft (Countershaft) Speed Sensor Replacement (A/T)
Remove the air cleaner assembly. Disconnect the output shaft (countershaft) speed sensor connector, and remove the output shaft (countershaft) speed sensor (A). ...

Intermediate Shaft Removal (A/T)
Drain the transmission fluid. Reinstall the drain plug with a new sealing washer. Remove the right driveshaft. Remove the shift cable cover (A). Re ...

Piston Installation
If the Crankshaft is Already Installed Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. Remove the connecting rod caps, and check that ...

© 2025 Copyright www.hfitinfo.com