Honda Fit: Dashboard Assembly

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Fuel Line Inspection
Check the fuel system lines and hoses for damage, leaks, and deterioration. Replace any damaged parts. Check all clamps, and make sure they are properly positioned and tightened. ...

Inboard Joint Side
Remove the boot bands. Be careful not to damage the boot. If the boot band is welded type (A), cut the boot band. If the boot band is a double loop type (B), lift up the ban ...