NOTE:
Put on gloves to protect your hands.
Take care not to scratch the body.
Remove the screws (A) and the clips (B, C), then remove the rear inner fender (D).
NOTE: To release the clips, pry up on the center pin at the notch (E).
Left side
Right side
Install the cover in the reverse order of removal, and note these items:
If the clips are damaged or stress-whitened, replace them with new ones.
Push the clips into place securely.
Secondary Shaft Disassembly, Inspection, and Reassembly (A/T)
Inspect the thrust needle bearings and the needle bearings for galling
and rough movement.
Inspect the splines for excessive wear and damage.
Check the shaft bearing s ...
Adding Engine Oil
Unscrew and remove the engine oil fill cap on the valve cover. Pour in the oil
slowly and carefully so you do not spill any. Clean up any spills immediately. Spilled
oil could damage components ...
Overheating
How to Handle Overheating
Overheating symptoms are as follows:
• The high temperature indicator comes on or the engine suddenly loses power.
• Steam or spray comes out of the engine compartment ...