Honda Fit: Interface Settings

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Fuel Pressure Regulator Replacement
Remove the fuel tank unit. Remove the reservoir (A). Remove the clip (B) and the ground wire (C), then remove the bracket (D). Remove the clip (E), then r ...

Wear Indicators
The groove where the wear indicator is located is 1/16 inch (1.6 mm) shallower than elsewhere on the tire. If the tread has worn so that the indicator is exposed, replace the tire. Worn out ti ...