Honda Fit manuals

Honda Fit: ATF Cooler Hose Replacement (A/T)

  1. Drain the automatic transmission fluid (ATF).

  1. Install the ATF cooler hoses over the ATF cooler lines, and secure the hoses with the clips in the details (A), (B), (C), and (D), shown in the following figure. Keep the tabs of the clips clear of other parts.

Details

Cooler hose end contacts to:

Distance from hose end to clip

A

Bulge

6пјЌ8 mm (0.24пјЌ0.31 in)

B

Bulge

2пјЌ4 mm (0.08пјЌ0.16 in)

C

ATF filter housing (both sides)

6пјЌ8 mm   (0.24-0.31 in)

D

Bracket on the line

6пјЌ8 mm (0.24пјЌ0.31 in)

  1. Refill the transmission with ATF.

See also:

Viewing the Route
Map Screen After calculating the route to your destination, the route is displayed on the map screen. As you drive, the system tracks your position on the map in real time and provides guida ...

MAF Sensor/IAT Sensor Replacement
Disconnect the MAF sensor/IAT sensor connector (A). Remove the screws (B). Remove the MAF sensor/IAT sensor (C). Install the parts in the reverse order of removal ...

Installation
Install the damper rubber mount (A) onto the damper unit. Position the damper assembly (B) between the body and the axle beam. NOTE: Be careful not to damage the body. ...

© 2026 Copyright www.hfitinfo.com